various articles

How to install a wall-mounted air conditioner?

In winter, when the cold is of moderate strength, the central heating may not work at full capacity. This may be due to various reasons - a rupture of the heating main, a lack of fuel in the boiler room and many other reasons due to which the apartment may be unusually cold.

And here electric heating devices will come to the rescue, among which may be Sensei air conditioners in Kiev... Their advantage will be that they will be useful not only in winter, but also in summer, if the weather is hot for a long time.

air conditioning

But even choosing a seemingly powerful and reliable air conditioner, the customer does not guarantee that his air conditioner will be able to develop the declared power and efficiency. The whole point will be in the correct installation of the air conditioner. If in this process even the slightest mistake is made, then the performance of this device will sharply decrease.

The first step is to pay attention to installation of an outdoor unit wall-mounted air conditioner. So that he cannot escape from his seat, then it will have to be properly strengthened. Here you will have to turn to a new technology for help: first, the craftsmen cut shallow (up to 10 cm) technological holes in the load-bearing wall of the house, where further, using an ordinary sledgehammer, steel pieces of reinforcement are driven in. Already on these very pieces the chassis of the air conditioner itself is welded. In order to be able to damp unnecessary vibration of the operating air conditioner, special rubber damping pads should be installed between the chassis and the external unit itself. And even the air conditioner will suddenly have a resonance (Chinese models often have this), then practically nothing will be heard or felt.

external block

But in winter, a large number of icicles can accumulate on the outer block. This, unfortunately, is observed all the time. And in order to prevent the outer block from falling down under the influence of an impressive amount of ice, it makes sense to install a small roof over the block, made of soft polyurethane tiles or metal tiles.

As soon as the outdoor unit is reliably "grabbed", it is the turn of the indoor unit. Installation of the indoor unit does not pose any particular problems as it is lightweight. It can be "put" either on anchor bolts or on dowels. The main thing is that the indoor unit is as high as possible in the room. This will allow the ambient air to circulate much better indoors.

As soon as the two blocks are securely fixed, the masters dry the system from air, pour in freon, set the condensate heating, and then thoroughly test it in all modes. And if all units are working normally, then the air conditioner is handed over to its customer.